ZENITH Technical Specifications

Review the antenna, low-noise amplifier, RF interface, mechanical, and environmental specifications of the Kalmix ZENITH full-band GNSS surveying antenna.

Antenna characteristics

The following table summarizes the RF and phase-center specifications for multi-frequency GNSS reception.

Parameter Specification
Frequency range BeiDou: B1, B2, B3
GPS: L1, L2, L5
GLONASS: G1, G2, G3
Galileo: E1, E5a, E5b, E6
L-Band
Peak gain 5.5 dBi
Polarization RHCP (Right-Hand Circular Polarization)
Axis ratio ≤ 3 dB
Phase center error ± 2 mm
Azimuth coverage 0° to 360°
VSWR (passive) ≤ 1.5
Impedance 50 Ω

LNA characteristics

The integrated low-noise amplifier supports receiver-side active-antenna integration across the published operating range.

Parameter Specification
LNA gain L1: 38 ± 2 dB · L2: 40 ± 2 dB
Noise figure ≤ 1.8 dB
Output VSWR ≤ 2.0
Passband ripple ± 2 dB
Operating voltage DC 3.3 V to 12 V
Operating current ≤ 50 mA

RF interface and installation

Review the antenna interface and mounting parameters before selecting receiver-side accessories and installation hardware.

Parameter Specification
RF connector TNC-K female
Mounting thread 5/8" × 11 TPI survey-standard thread
Receiver compatibility GNSS receiver with an external active-antenna input and compatible antenna bias supply.
RF cable Not included. Select the cable separately according to the receiver-side RF interface and installation path.

Environmental characteristics

The following limits apply to outdoor deployment and storage.

Parameter Specification
Ingress protection IP67-rated enclosure
Operating temperature −40°C to +85°C
Storage temperature −55°C to +85°C
Storage humidity 95% non-condensing

Integration references

Use the remaining ZENITH documentation for product scope, mechanical dimensions, and available compliance information.

Product evaluation

Evaluating ZENITH for your GNSS system?

Review the antenna specifications or discuss a GNSS hardware requirement with the Kalmix team.