GUIDE K35 Series Mechanical & Dimensions
Review the GUIDE K35 Series 24-pin LCC package dimensions and mechanical references before finalizing the carrier-board footprint, component placement, and surface-mount assembly design.
Package overview
GUIDE uses a compact surface-mount LCC package designed for direct carrier-board integration. Use the mechanical drawing and dimension table together when preparing the PCB layout.
Surface-mount leadless package for embedded GNSS carrier-board designs.
Typical module body dimensions based on symbols A and B in the mechanical drawing.
Typical package height based on symbol C in the mechanical drawing.
Mechanical drawing
The drawing below provides the top, side, and detail views of the GUIDE K35 Series package. Dimension symbols correspond directly to the physical specification table.
Physical specifications
Use the following minimum, typical, and maximum values together with the mechanical drawing when defining the carrier-board footprint and assembly constraints.
| Symbol | Minimum (mm) | Typical (mm) | Maximum (mm) |
|---|---|---|---|
| A | 16.0 | 16.3 | 16.6 |
| B | 12.05 | 12.2 | 12.35 |
| C | 2.2 | 2.4 | 2.6 |
| D | 0.9 | 1.0 | 1.3 |
| E | 1.0 | 1.1 | 1.2 |
| F | 2.9 | 3.0 | 3.1 |
| G | 0.9 | 1.0 | 1.3 |
| H | — | 0.82 | — |
| K | 0.7 | 0.8 | 0.9 |
| M | 0.8 | 0.9 | 1.0 |
| N | 0.4 | 0.5 | 0.6 |
Continue with the documentation
Continue with the module specifications, carrier-board pin definitions, or receiver-level protocol documentation.
Evaluating GUIDE for your hardware design?
Review the product page or discuss a module-level integration requirement with the Kalmix team.